How do I troubleshoot my electric bike?

How do I reset my ebike battery?

To reset the battery management system, do the following:

  1. Remove the battery from the battery mount.
  2. Press and hold the On/Off button on the battery for 10 seconds.
  3. The battery management system should now be reset. Re-install the battery and turn on the bike.

How do I test my ebike controller?

As a general rule, you can test your ebike controller by measuring the resistance of the MOSFETs inside the controller. you can tell that your controller is working normally if there is no short between the MOSFETs and the two battery lines.

How do I turn on my ebike controller?

Press the MODE button on your controller for 2-3 seconds and the display should turn on. To turn it off, simply press the RED button and everything will shut down.

Why is electric bike not working?

Check if there are any burned or melted wires, electrical components or wire connectors. You should also look for disconnected, loose or damaged wires or wire connectors. Pull and push on all the individual wires and wire connectors and make sure that they are not loose or disconnected. Try to smell the controller.

THIS IS IMPORTANT:  Are clutch wheelies bad for your bike?

How do you troubleshoot an ebike battery?

To diagnose your e-bike’s battery problem, start by charging the battery and then inspect the charger. Check the battery for misalignments or loose connections, and make sure the battery’s life cycle is within its limits. Examine the BMS to ensure that it’s in good working condition.

Why my pedal assist is not working?

Unplug and inspect the PAS sensor connector.

Unplug the connector by pulling each side directly apart without twisting. Inspect the inside of the connector for dirt, damage, or moisture. If the inside of the connector is dirty, damaged, or wet, the sensor may need to be replaced.

How do you wake up an ebike battery?

Here’s the process for properly waking your battery:

  1. Put the battery on the bike.
  2. Plug the charging tip into the battery.
  3. Plug the charger into the wall.
  4. Tap the power button on the battery once to turn it on.
  5. Press and hold the “M” on the controls to turn on the display.
  6. Leave the battery on the bike to charge overnight.

What is the lifespan of an electric bike battery?

In fact, Bosch themselves state that the battery should be good for around 10 years or 1500 full charge cycles. After 1500 cycles the battery will still work, but any battery will age over time so it will start to lose capacity and therefore not power your electric bike as far.