Best answer: What should your sag be set to on your mountain bike?

Most manufacturers recommend that you set your sag somewhere between 25 to 35 percent. If your sag is higher or lower than that, you need to make some adjustments by attaching your shock pump and increasing or decreasing the air pressure in the shock and running the calculation again.

What should my rear sag be?

For the rear shock – 20% – 30% sag is recommended. For the most part, this can be used across the board for trail bikes and downhill bikes. Again, keep in mind you may want more or less sag depending on your bike, weight, and riding preferences. For the front fork- 10% sag is recommended.

How much sag should you run?

Traditionally, it was often said that you should run about 25% sag for cross-country and about 30% for everything else. But modern bikes generally have more progressive linkages and radically better air shocks with volume spacers to control bottom-out.

How important is SAG MTB?

Setting sag is the first (and arguably most important) step to dialing in the suspension on your mountain bike. Sag is static ride height. That is, the amount your shocks compress when you’re in your regular riding position.

THIS IS IMPORTANT:  Quick Answer: How fast do A2 bikes go?

How do I set my SAG?

To change the sag, use a long punch and a large hammer to loosen the spring locking nut on the shock. 4. Then, turn the spring with your hand to adjust the rear spring preload. Make sure that when you’re turning the spring, the preload nut is also turning.

What PSI should my mountain bike shocks be?

Often yes, usually rear shocks run 100-200psi, but fork psi varies a lot, depending on the design. Get the sag around 25% (maybe slightly less sag in the front than the rear) and see how it rides (that’s what really matters), adjust on the trail as needed.

What is sag setting?

Rider sag is the measurement of how much the forks and shock compress when you get on the bike. Setting the sag lets you change where in the range your suspension ‘sits’ with you on board, and it gives the suspension an initial point to work in either direction.

What PSI should rear shocks be?

For the rear shock, start at about half of your rider weight for air pressure. You will have to adjust from here, but you will want to achieve the proper SAG for your frame, as recommended by your frame manufacturer. Typically this is somewhere between 30-40% of overall travel.

How much sag is trail riding?

The amount of recommended sag will vary depending on the type of bike that you ride. Typically, enduro/trail bikes fall between 25% – 35% recommended sag, while downhill bikes can be up to 40% recommended sag.

THIS IS IMPORTANT:  Do bikes or cars have the right of way?

What is small bump sensitivity?

Small bump means trail chatter. Like pebbles and washboard stuff. Basically suspension performance right at sag.

Should front and rear sag be the same?

A general rule of thumb is that the front sag should be about 30-35% of travel, while the back should be at about 25%. That works out to be 30-40mm at the front and 25-35mm at the back, for most bikes.

What should static sag be?

Aim for approximately 30mm of static sag for street riding and 25mm for the track. If you have too much sag, tighten up the front preload. Too little, and you’ll have to loosen the adjusters accordingly. One turn on the adjuster will usually change sag by about one millimeter.

How much sag should my forks have?

For fork sag you should be aiming for 25% sag. So a 140mm travel fork should have 35mm of sag.

How much air should I put in my fork?

To achieve the best performance from your FOX suspension, adjust the air pressure to attain your proper sag setting. Sag is the amount your suspension compresses under your weight and riding gear. Sag range should be set to 15–20% of total fork travel.